Embossing Leveler Over Old Vinyl

Linoleum or vinyl flooring.

Embossing leveler over old vinyl.

Spread emboss floor leveler with a smooth edge trowel holding the trowel at a 45 to 60 degree angle. An embossing leveler should be applied and the new vinyl should be installed over the existing vinyl. Found this on a flooring site. To properly install a new tile surface you should remove the existing vinyl tile grind down as much of the old tile adhesive as possible and then apply the leveling compound to smooth out the surface for the new tile.

Work quickly because the leveler will start to dry after about 10 minutes. The aim of an embossing leveler is to reduce any effects which are the results of seams depressions and the quality of the existing floor when you install the new floor on top of it. The embossing leveler also ensures you have a good surface to apply the new tiles over. Applied with a straightedge trowel the embosser will create a smooth surface to support the new floor.

The old vinyl is probably 30 years old probably older. An embossing leveler goes directly over the old vinyl and fills in any pattern lines or small dents and scratches. Hold a flat edged trowel at a 45 degree angle to the floor and smooth the embossing leveler over the existing floor. Emboss floor leveler dries very quickly so work fast.

Sheet vinyl can be laid over old linoleum or vinyl flooring if the existing floor is in good condition. When the emboss floor leveler is properly mixed the consistency will fill depressions in the old floor covering with ease. Keep in mind that if you do not apply embossing leveler over the old floor s design it will appear through the surface of your new floor as well especially. If you have large rips or dents you will need to fill those in with a floor patch prior to leveling.

It can be confusing because many leveling compounds are marked as useable on a variety of surfaces including linoleum and vinyl. Sheet vinyl installation over a skim coated vinyl floor makevinylgreatagain how to. 2 follow the instructions. So embossing leveler sounds like a possibility.