Epoxy Floor Adhesion Test

The test determines the greatest perpendicular force in tension that a surface area can bear before a plug of material is detached.

Epoxy floor adhesion test.

The coating stuck extremely well causing the concrete to fail. The industry standard epoxy flooring test method is called the taber c 17 abrasion test. Test results were discussed and analyzed. Epoxy could not be separated from concrete.

Adhesion pulley test a total of five different epoxy primer sealers were tested in the adhesion pulley test. 106 adhesion testing kit vbp 4195 direct to concrete epoxy kit competitor a epoxy kit competitor b epoxy kit competitor c epoxy kit competitor big box epoxy kit concrete mixing materials and application materials. Failure will occur along the weakest plane within the system comprised of the loading fixture glue coating system and substrate and will be exposed. The instructions for this type of adhesive state that the two components resin and hardener should be mixed in equal parts usually equal lengths of both parts.

The adhesion pully test demonstrated that this coating pulled the most concrete from the floor. Big box epoxy did not break. During adhesion testing with elcometer pull tester top layer of concrete slab pulled off with no delamination of our epoxies. Cleaning your epoxy floor.

Anything under 300 psi means it can be separated from your concrete floor. Adhesive mixing the test dolly should be glued to the surface using a suitable adhesive. By use of a portable pull off adhesion tester a load is increasingly applied to the surface until the dolly is pulled off. 1 1 this test method covers procedures for evaluating the pull off adhesion strength of a coating on concrete.

Read to find out more about prepping concrete for a urethane coating. At thermalchem we promise to provide the best resources for your epoxy flooring. All other test methods are just marketing gobble d gook. Operators and different adhesion test procedures.

Implementation a test procedure to evaluate the adhesive strength of the epoxy coating was developed and is recommended for quality control. The force required to pull the dolly off or the force the dolly. What the taber c 17 test does is to take a coating and apply an abrasion wheel with a certain weight on it and spin it at a certain rpm for a certain amount of time. Typically a two pack epoxy adhesive is supplied with adhesion test units.

Different adhesion rating systems were devised and evaluated. Elcometer adhesion puller was attached to the adhesion pulleys and the test was run. Our epoxy wicks into the concrete and is much better than our competitors.